Loctite 518 keo thay thế gioăng
Top Pick Loctite® 518™ Gasket Eliminator® Flange Sealant chất trám kháng dung môi, không rách hoặc phân rã. Chịu được tới 300 ° F và lấp đầy những khoảng trống đến 0,05 “với sơn lót. Đề xuất sử dụng trên mặt bích cứng bằng sắt, thép và nhôm. Dễ dàng tháo gỡ và làm sạch. Ứng dụng trong hộp số, vỏ bọc động cơ.
Keo 518, keo dán 518, keo dán loctite 518, loctite 518
Mô tả: Màu đỏ
Khe hở: 0.010”(0.25mm)
Phương thức đông kết: Hiếm khí
Thời gian đông kết (tối thiểu/hoàn toàn): Không áp dụng / 24 giờ
Khả năng chịu nhiệt (Liên tục/Gián đoạn): 300ºF(150ºC) / Không áp dụng
Làm kín nhanh : Rất tốt
Quy cách – mã sản phẩm: Tuýp 50ml hoặc Ống 300ml
Loctite 518 Gasket Eliminator Flange Sealant: Hình thành lớp roăn dẻo, chịu được dung môi không rã hay nứt. Chịu được nhiệt độ đến 300ºF và bịt kẽ hở lên đến 0.050″ (nếu sử dụng primer). Có thể sử dụng trên các bề mặt kim loại dẻo như nhôm. Dễ tháo và vệ sinh.
Features and Benefits
Medium-strength, general purpose gasketing product – excellent contamination tolerance. Ideal for use on casted iron, steel and aluminum flanges.
LOCTITE® 518 cures when confined in the absence of air between close-fitting metal surfaces. It is an anaerobic gasketing material designed for use on rigid iron, aluminum, and steel flanged mating surfaces. Fills gaps up to 0.25mm and forms a flexible, chemical-resistant seal that will not tear or decay. Parts disassemble easily, even after extended service. Typical applications include sealing close-fitting joints between rigid metal faces and flanges. It is also used as a formed-in-place gasket on rigid flanged connections, e.g. transmissions and motor housings. NEW: Henkel has recently improved the product formulation of LOCTITE® 518 providing:
- Higher strength on contaminated surfaces
- Better flexibility and improved adhesion
- Enhanced sealing capability
- Improved gap cure
- High performance on passive metals without an activator
- Semi-flexible, medium-strength anaerobic flange gasket
- For active and inactive rigid metal flanges
- Cures through minor surface contamination
- Adapts to flange surface irregularities and gaps up to 0.25 mm
- Gel-type consistency
- Seals instantly against low pressure
- Reduces inventory costs – no need for large inventory of cut gaskets
- Resists high pressure when fully cured
- No compression set or misaligned gaskets
- Easy to automate
- Reduces process costs – eliminates manual assembly of conventional gaskets
- NSF P1 Reg. No. 123758
Gọi: 039.831.9580